Intro In this tutorial, I'll show you how to adjust your Cura settings to get your printer up and running and thereby avoid using DaVinci software. Most likely, you are reading this because you use Linux. Brace yourself, because you'll need to tear a hole in the side of your machine to access the SD card. I know it sounds crazy, and I wish I was kidding, but this is the reality of proprietary 3D printers. I've provided the start and end GCodes for easier copy/pasting at the bottom of this article. Related project: There is an Open Source software pacakge on GitHub called MiniMover that suppose
https://rickcarlino.com/2021/cura-settings-for-xyz-davinci-1-0.html
Image:
Image:
https://rickcarlino.com/2021/cura-settings-for-xyz-davinci-1-0.html
Image:
Image:
Views: 5
Categories: General [c1], Technology & Open Source [c124]